Filter
Top Products
4-18 Dell PowerEdge 4200 Systems Service Manual
S
ystem Board
Figure 4-17. System Board Removal
1. If possible, enter the System Setup program and copy information from
the system setup screens.
2. Disconnect all cables from their connectors at the back of the system
unit.
3. Remove all expansion cards.
4. Disconnect all cables from the system board.
5. Remove the screw that secures the system board to the vertical wall of
the computer chassis.
6. Slide the system board toward the front of the computer approximately
1/2
inch to release the board from the 13 slots in the computer chassis.
7. Lift the system board out of the computer.
NOTE: If you are replacing a system board, remove the DIMMs, the single-
edge contact (SEC) cartridge/heat sink assembly and terminator card (or
second SEC cartridge/heat sink assembly), both guide bracket assemblies,
and the expansion card(s) from the old system board and install them on the
replacement board. Also reconfigure the board’s jumpers (see Figure 1-19)
screw
system board