Filter
Top Products
4-10 Dell PowerEdge 4200 Systems Service Manual
S
CSI Backplane Board
Figure 4-10. SCSI Backplane Board Removal
1. Disconnect the hard-disk drive carrier connectors from the SCSI back-
plane board by sliding each carrier toward the front of the computer
approximately 1 inch.
2. Disconnect all cables from the SCSI backplane board.
3. Remove the thumb screw.
4. Disengage the board from the hooks holding the board to the computer
chassis, and lift the board away from the computer.
An insulator (similar to the one for the power supply paralleling board in
Figure 4-13) is attached to the back of the SCSI backplane board with two
adhesive strips. Ensure that this insulator is in place when installing the
backplane.
SCSI backplane board
hard-disk drive
carrier
thumb screw
hooks (10)