Filter
Top Products
System Setup Program A-1
Appendix A
System Setup Program
T
his appendix describes the System Setup program, which is used to set or
change the system configuration information stored in NVRAM on the system
board.
To enter the System Setup program, press <F2> during the power-on self-test. If
you wait too long, the operating system begins to load into memory and you
cannot enter the System Setup program. Let the system complete the load operation;
then shut down the system and try again.
NOTE: To ensure an orderly system shutdown, consult the documentation that
accompanied the operating system.
S
ystem Setup Screens
The System Setup program is a menu-driven program. Use the left- and right-
arrow keys to move among the following four menus:
•
Main menu — Provides settings for the basic system configuration
•
Advanced menu — Provides detailed settings for some system features
•
Security menu — Provides settings for password status, diskette access,
virus check reminder, and system backup reminder
•
Exit menu — Provides settings for saving and loading the configurations
and options
In addition to the initial menu selections, some selections have submenus.
These submenus are identified by an arrow to the left of the selection.
Screen Conventions
Information on the System Setup screens is organized in four boxed areas (see
Figure A-1):
•
Title box — Contains information about the system and menu selections
•
Configuration options and system data box — Lists configuration categories
(left column) and settings or information (right column)
•
Help box — Displays item-specific help for the category whose field is cur-
rently highlighted
•
Key functions box — Lists the System Setup keys and their functions