Mitsubishi Electronics DX-TL1600EM DVR User Manual


  Open as PDF
of 86
 
46
•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
•
<CAMERA TITLE>
CH TITLE
@
O
................
P
................
{
................
}
................
q
................
w
................
e
................
r
................
4. Turn the JOG dial to the right to move the cursor next to CH
5
and turn the SHUTTLE ring to the right to flash the first
column of the TITLE setting.
4
................
@
5
................
6
................
5. Turn the JOG dial to display “E” and turn the SHUTTLE ring
to the right to move the flashing to next column.
4
................
@
5
E...............
6
................
4
................
@
5
EXIT............
6
................
6. Repeat Steps 4 and 5 to input “EXIT” .
• Turning the SHUTTLE ring to the left while inputting will
erase the character. To exit the TITLE column, move the
flashing to the right end, then turn the SHUTTLE ring to the
right to fix title setting.
• To continue title setting, turn the JOG dial to move the cursor
to desired camera CH.
4
................
@
5
EXIT............
6
................
4
................
@
5
EXIT............
6
................
7. To finish setting, turn the SHUTTLE ring to the left or press
the SET UP button.
• You cannot exit the menu till you complete title setting. To
fix the setting please refer to step 4.
♦ Alarm display setting
During alarm signal input, display will be changed from the
regular screen or split-screen modes to show images from
the camera responsible for the alarm signal. If, during Alarm
Recording, a different Alarm Recording is initiated, images
from the newest alarm input channel will be shown on a
single-screen display. The screen display will revert to its
original state upon completion of Alarm Recording.
Example: Setting the ALARM DISPLAY to “OFF” (the de-
fault setting is “ON”).
1. Press the SET UP button to display the <MENU SETTING>
menu.
2. Move the cursor (
) to MPX DISPLAY then turn the
SHUTTLE ring to the right.
• The <MPX DISPLAY> menu will appear.
<MPX DISPLAY>
@SCREEN SW PATTERN ALL
SPLIT 4 SCREEN SETTING
SPLIT 9 SCREEN SETTING
SPLIT 16 SCREEN SETTING
IMAGE QLTY HIGH
SEQUENCE
CH.TITLE CH.NO
CAMERA TITLE
ALARM DISPALY ON
3. Turn the JOG dial to move the cursor to ALARM DISPLAY
and turn the SHUTTLE ring to the right.
• The sub-item flashes.
<MPX DISPLAY>
SCREEN SW PATTERN ALL
SPLIT 4 SCREEN SETTING
SPLIT 9 SCREEN SETTING
SPLIT 16 SCREEN SETTING
IMAGE QLTY HIGH 
SEQUENCE
CH.TITLE CH.NO
CAMERA TITLE
@ALARM DISPALY ON
4. Turn the JOG dial until “OFF” flashes and turn the SHUTTLE
ring to the right.
• The sub-item stops flashing.
<MPX DISPLAY>
SCREEN SW PATTERN ALL
SPLIT 4 SCREEN SETTING
SPLIT 9 SCREEN SETTING
SPLIT 16 SCREEN SETTING
IMAGE QLTY HIGH
SEQUENCE
CH.TITLE CH.NO
CAMERA TITLE
@ALARM DISPALY OFF
5. Turn the SHUTTLE ring to the left or press the SET UP
button.
Multiplexer functions (continued)
 previous next