Filter
Top Products
94
RQT9487
Software of this unit can be updated automatically by following
method.
y From broadcasts
y From Internet [network connection and setting is required. (➡ 92,
98)]
Update of the software is done when it is in standby mode.
Once the new software is found, it will start the download of the
software, and then the update.
Download of the software will start automatically when the power of
this unit is turned off or when it is 3 a.m.
y The time it takes to update depends on the connection.
– For Broadcast: About 30 minutes to 1 hour
– For Internet: About 1 hour
(It may take longer than specifi ed above to download because
the download time differs depending on the network
environment. It is recommended to be used in a broadband
environment.)
If you do not want to perform the software update during the
standby mode, set “Software Update in Standby” in the Setup menu
to “Off”. (➡ 90)
■ If a software update is available, a notifi cation is
displayed.
For broadcast
1 TEN HD
All DVB Channels
10:30
Select Favourites
Coronation street
9:00 - 11:00
Now
Rating:PG
Software update
Software update
y Following screen is displayed when “Red” button is pressed.
For Internet
y Update of the software will start when the power is turned off.
■ The unit’s display during the update
y “SW-DL” : Software is downloading. Download will stop
when the power is turned on, or the timer
recording starts.
y “START”
Ú
: Update of the software will start once the
download is completed.
y “UPD /”
Ú
: Software is updating.
y “FINISH” : Updated of the software has completed.
Ú
You cannot operate the unit until the update is complete.
Removing the AC mains lead while the update is in progress
may damage the unit.
Note
y If the timer recording is scheduled within the following time at the
start of the download, the download will not be executed.
– For broadcast: Within 1 hour
– For Internet: Within 1 hour
y If downloading on this unit fails or this unit is not connected to the
Internet, then you can download the latest software from the
following website and burn it to a CD-R to update the software.
http://panasonic.net/support/
Software (Firmware) Update