129
Mirroring is a function that camera images are recorded
into 2 hard disks simultaneously. In case that one hard disk
fails, normal image data stays in the other hard disk. The
credibility of disk can be enhanced.
It is recommended to activate the mirroring function for the
first use of this unit. If the mirroring function is activated
when images are stored in the hard disk, recorded images
will be deleted.
Note: If the hard disk is changed or taken out, the top page
of the disk configuration menu automatically appears.
● Start of mirroring
You can activate the mirroring function by following the pro-
cedure below.
z Turn on this unit and press the [SET] button after com-
pletion of system check.
Note: If the hard disk is taken out, the top page of the
disk configuration menu automatically appears.
[Screenshot 1]
The top page of the disk configuration menu appears.
x Press the arrows button (A and B) to move the cursor
to "Format" and press the [SET] button.
[Screenshot 2]
The password entry screen appears.
■ Setting on Mirroring
c Press the camera selection button and type the pass-
word.
v Press the arrows button (C and D) to move the cursor
to "OK" and press the [SET] button.
[Screenshot 3]
The format screen appears.
b Press the arrows button (A and B) to move the cursor
to "Mirror Format" and press the [SET] button.
[Screenshot 4]
The setting screen of mirror disk record area appears.
n Press the arrows button (A, B, C and D) to select a
recording area and rotate the jog dial to set the capaci-
ty of selected recording area.
For deciding the capacity of two or more recording
areas, repeat this procedure.
m Press the [SET] button after setting.