Filter
Top Products
96
<DURATION>
Move the cursor to a parameter box of each area using
the arrows button (B) and rotate the jog dial to select a
moving duration for an object in each area from the fol-
lowing.
--/5 s/10 s/20 s/30 s/40 s/50 s/1 m
c To complete the settings, rotate the jog dial to select
"EXIT" on the status bar, and press the SET button.
→ The "VMD Setup" window will be closed.
● About the Detection mode
Perform the settings of the detection mode (method of
detection) in the set detection area. Specifying a method of
detection in a detection area is available by the setting
detection mode.
There are three detection modes as follows.
Important:
Activating two or more detection modes simultaneously
is not possible.
<ANY AREA (to detect "motion" in the area)>
An event action will be performed according to the set-
tings when "motion" is detected in any of the set motion
detection areas.
Any motion will be detected anywhere in the A, B, C, D
areas.
<VECTOR (to detect object moving to a certain direc-
tion)>
An event action will be performed according to the set-
tings when an object moves within the set time to the
other detection area in the set order.
The following is an example.
Motion is detected in area B within 10 seconds after
being detected in area A.
Motion is detected in area C within 20 seconds after
being detected in area B.
Motion is detected in area D within 10 seconds after
being detected in area C.
When all of the above have occurred, an event action
will be performed.
<DURATION (to detect object keeps on moving in the
area)>
An event action will be performed according to the set-
tings when an object keeps on moving for the set peri-
od in the detection area. For example, in case of the fol-
lowing settings; 10 sec. for the area A and B, 20 sec.
for area C and 30 sec. for area D:
An event action will be performed when an object
keeps on moving for 10 seconds in area A or B, or for
20 seconds in area C, or for 30 seconds in area D.
e [Alarm Setup] Perform the settings
for alarm auto reset and alarm
disarm
Perform the settings for the alarm displaying duration.
The alarm display will automatically disappear when the
displaying duration has passed. (Alarm Auto Reset)
Perform the settings to suspend the set duration when
the same type of the event (motion detection, video
loss, terminal alarm, command alarm) has occurred
sequentially so that the event action will not be per-
formed each time. (Alarm Disarm)
10 sec.
10 sec.
20 sec.
Event Schedule
System
Display
Com
Switcher
SETUP MENU
LIVE
Maintenance Recording
Event Setup
VMD Setup
Alarm Setup
Terminal Setup
OFF
2s
■
Alarm Auto Reset
■
Alarm Disarm Time