Filter
Top Products
78
● Connection for the Auto Time Adjust function
• When "AutoTime Adjust" of "System" on the SETUP MENU is set to "MASTER"
"Time Adjust Output" becomes available and the clock of this unit can be applied to other units.
• When "Auto Time Adjust" of "System"on the SETUP MENU is set to "SLAVE"
"Time Adjust Input" becomes available. When a signal output from other equipment is supplied to the time adjust I/O terminals
between 00 minutes 00 seconds and 14 minutes 59 seconds every hour or between 45 minutes 00 seconds and 59 minutes
59 seconds every hour, the clock will be set to "00 minutes 00 seconds" of the closest hour .
Example:
Signal is supplied at 2:50:00 (hour:minute:second)pm → Set at 3:00:00 pmM
Signal input supplied at 3:14:45 pm → Set at 3:00:00 pm
Signal issupplied at 3:20:00 pm → Time will not be adjusted.
Terminal block of other units
(Time adjust output)
(Earth)
ALARM/CONTOROL
Earth
Sensor input
Alarm input
Alarm reset input
Series recording input
Time adjust input
Earth
Alarm output
Alarm reset output
Alarm recording
During recording
Disk
Buzzer output
System error output
Temperature error output
Time adjust output
Series recording output
(13) (20)
Front LED
monitor
output
ALARM/CONTOROL
Terminal block of other units
Earth
Sensor input
Alarm input
Alarm reset input
Series recording input
Time adjust input
Earth
Alarm output
Alarm reset output
Alarm recording
During recording
Disk
Buzzer output
System error output
Temperature error output
Time adjust output
Series recording output
Front LED
monitor
output
(Time adjust output)
(Earth)
(13) (20)