Sanyo VA-SW8000 DVR User Manual


 
119 English
DVR Management Menu (Required user access level: ID4)
1
Choose a channel.
For example, select the “CH1” radio
button if you want to configure the
settings for channel 1.
2
Set the sensitivity level of the motion
sensor.
Select the appropriate option from the
[LEVEL] drop-down list.
Valid range: OFF, 1 (high) to 10 (low)
3
Click .
The preview pane displays a snapshot
(still image) of the video from your
selected channel.
4
Define sensing points by clicking on
the preview pane.
On the preview pane, click grid squares
where to position sensing points. To
apply a sensing point to a grid square,
click the grid square once; to remove the
sensing point, click the square again.
Transparent:
Sensing point applied.
Opaque:
Sensing point not applied.
5
Enter the camera title for the current
channel into the [CAMERA TITLE] box.
A camera title can contain uppercase
letters and numbers, up to 10 characters
in all. It can also contain these special
characters: - : / *. and space.
Defaults:
By default, channel numbers (1 to 4) are
used as camera titles.
(CH1: 1, CH2: 2, CH3: 3, CH4: 4)
6
Click .
This applies the motion sensor and
camera title settings to your specified
channel .
7
Configure the motion sensor and
camera title settings for other
channels (CH2-CH4).
Repeat the above procedure (steps 1 to
6).
You can apply up to 20 sensing
points to the middle area of the
preview pane, where 20 grid
squares are displayed in a
4-column and 5-row layout.
This system supports two different
sets of camera titles: those for
DVR’s user interface and those for
the DVR Utility Software’s user
interface. These two different
camera title sets are configured on
two discrete configuration
windows.
What you configure here are
camera titles for DVR’s user
interface. When you want to
configure camera titles displayed
on the DVR Utility Software's user
interface, you must use the [Tree
Edit] window accessible from the
[Initial Set] menu.
For more information, see P76.
When you have finished your
configuration task across all the
channels, finally click .
Configuration information is uploaded to
the DVR, and the tab index text returns
from yellow to black.
(For more information on the command
buttons, see P103.)