Filter
Top Products
299
Troubleshooting Dépannage
Symptom Cause and/or Corrective Action
• DISPLAY is set to V-OUT/LCD in the menu settings.
c Set it to LCD (p. 277).
• Moisture condensation has occurred.
c Eject the cassette and leave your camcorder for at least one
hour to acclimatise (p. 331).
• Some trouble has occurred in your camcorder.
c Eject the cassette and insert it again, then operate your
camcorder.
• The POWER switch is not set to OFF (CHG).
c Set it to OFF (CHG).
• The POWER switch is not set to OFF (CHG).
c Set it to OFF (CHG).
• The battery pack is not installed properly.
c Install it properly (p. 28).
• The battery pack is fully discharged.
c Install a fully charged battery pack.
c Disconnect the mains lead of the AC Adaptor or remove the
battery, then reconnect it in about one minute. Turn the
power on. If the functions still do not work, open the LCD
panel and press the RESET button using a sharp-pointed
object. (If you press the RESET button, all the settings
including the date and time return to their defaults.) (p. 350)
• Your camcorder was connected to your computer with the USB
cable before installing the USB driver, so the driver was not
recognised by the computer.
c Uninstall the unrecognised driver, and then reinstall the
driver (p. 240).
The picture from a TV or VCR does
not appear on the screen even when
your camcorder is connected to the
outputs of other equipment
(connected with the A/V cable).*
3)
The melody or beep sounds for five
seconds.
You cannot charge the battery pack.
The BATTERY INFO is not
displayed.
No function works though the power
is on.
You cannot install the USB driver.*
6)
*
1)
*
2)
*
3)
*
4)
*
5)
*
6)
(continued on the following page)
Types of trouble and how to correct trouble