Filter
Top Products
148
A/C-7P RO, A/C-7S RO
Appendix E: Transferring Power
to Pin 18
To transfer power to pin 18 of the parallel input connector of the A/C-7P RO,
you must move a jumper on the A/C-7P RO board. To move this jumper do the
following:
1.Power off the printer, the A/C-7P RO, and the attached PC or LAN print
server.
2.Disconnect all cables from the A/C-7P RO.
3.Remove the two black screws from the outside of the back panel.
4.Pull out the A/C-7P RO’s back panel, together with the attached board.
5.Locate the jumper in the lower left corner, right above the parallel
connector labeled “Parallel In From PC/LAN” (see Figure E-1).
6.Remove the black jumper from the pin, then reinsert it covering both pins
(see Figures E-1a and E1-b).
Figure E-1a.
Figure E-1b.
Figure E-1. Jumpers.