Filter
Top Products
45
A/C-7P RO, A/C-7S RO
COMMAND 42: START AND
STOP EBCDIC HEX DUMP
After receiving a start command the
coax interface, starting with the next
buffer received, sends all host data
directly to the printer as
hexadecimal printing until a stop
command is received or the printer
is powered off.
VALUE DESCRIPTION
*0 No action taken
1 Start EBCDIC hex
dump
2 Stop EBCDIC hex
dump
NOTES
This command enables the
user to print only the section
of the document that is in
question in buffer hex dump
format.
Hex printing starts with the
buffer after the start
command and stops with the
buffer after the stop
command.
Examples: &%Z42,1 starts buffer
hex dump printing; &%Z42,2 stops
buffer hex dump printing.
COMMAND 45: SCS TRN
TRANSLATE
Specifies how transparent data sent
using SCS code 35 is handled.
VALUE DESCRIPTION
0 Binary Transparent
*1 Emulate IBM 3287
Printer
NOTES
Value 1 causes valid graphic
characters to be printed
normally (i.e., converted
from EBCDIC to ASCII), while
control codes and invalid
graphics are printed as
hyphens, and normal page
formatting is maintained.
Value 0 causes the 8-bit
binary codes to be sent
directly to the printer just as
they are received from the
host.
SCS code 36 functions the
same as code 35.
Available in SCS (LU1) mode
only.
Example: &%Z45,0—All SCS Code
35 data is sent to the printer as
binary codes without translation.
*Factory-default setting.