Filter
Top Products
56
A/C-7P RO, A/C-7S RO
NOTES
If a document is printed
using temporary host
download commands
(commands not stored using
the Z99,0 command), value 2
will restore the permanent
memory selections.
Put a &%Z98,2 at the end of
the document to restore the
standard setup parameters
for the next user of the
printer.
The active setup and
permanent memory setup
selections are the same after
a Command Z99,0 or a
Command Z98,2 is sent to
the printer.
Example: &%Z98,1 prints out the
active setup selections for review.
COMMAND 99: STORE
CONFIGURATION IN
PERMANENT MEMORY
Send this command after all desired
host download configuration
commands have been sent to the
interface. It stores the active setup in
the permanent memory of the
interface so it will be in effect
whenever the printer is powered on.
Otherwise, active configuration
commands are lost when the printer
is turned off.
VALUE
DESCRIPTION
0 To complete the
command, the
value 0 must be
used
NOTES
Host download selections
followed by a Command
Z99,0 will be stored in
permanent memory and
active when the printer is
turned on.
Only use Command Z99,0
when the host download
selection needs to be
permanently stored in the
memory of the interface.
Example: &%Z99,0 stores the
currently active setup selections in
the permanent memory of the
interface.