Filter
Top Products
52
A/C-7P RO, A/C-7S RO
Previously stored substi-
tutions are cancelled if an
ASCII hex sequence of 00 is
specified.
Command Z99,0 must be
used to store the
substitutions in permanent
memory for them to be
effective when the printer is
next turned on.
The active EBCDIC
(SCS/LU1) translation table
prints out at the end of the
interface self-test summary.
Example: &%Z70,7B,40/Z99,0
prints a 40 ASCII hex (a @ symbol)
when the interface receives an
EBCDIC 7B (a # symbol). The
command is followed by a command
Z99,0 which stores the active setup
selections in permanent memory.
COMMAND 71: OVERWRITE DSC
(LU3) TRANSLATION TABLE
Custom substitutions defined by this
command, and stored in the
permanent memory, are overwritten
into the DSC (LU3) to ASCII
translation table.
NOTES
This command functions
similarly to Command 70
except the substitutions are
applicable to the DSC (LU3)
translation table. Refer to the
Command 70 instructions.
The active DSC (LU3)
translation table prints out at
the end of the interface self-
test summary.
COMMAND 76: SERIAL-IN BAUD
RATE
Selects the Baud Rate for data
received at the serial-in port. A new
setting will not be effective
immediately. To activate the new
setting, cycle power on the interface.
VALUE DESCRIPTION
0 38,400 baud
1 19,200 baud
*2 9,600 baud
3 4,800 baud
4 2,400 baud
5 1,200 baud
6 600 baud
7 300 baud
Example: &%Z76,0 sets the
receiving baud rate to 38,400