Filter
Top Products
51
A/C-7P RO, A/C-7S RO
Example: &%Z64,1 specifies that all
printing using paper from the
manual feed slot will be printed in
portrait orientation.
COMMAND 65: CHARACTER SET
SELECTION
Enables the user to select the ASCII
character set that is used in the
conversion from EBCDIC
(SCS/LU1) or DSC (LU3) to ASCII.
This selection automatically changes
to match the output protocol
selected through the interface’s
configuration switches if HP, PPDS,
or Proprinter II modes are chosen.
The other selections require the user
to manually select the appropriate
character set.
VALUE DESCRIPTION
1 Roman 8 character
set (HP PCL)
2 Code Page 850
character set (IBM
PPDS, Epson
ESC/P2, Generic)
3 IBM PC Extended
(Code Page 437)
and Epson
Graphics (PC Set 2)
NOTES
The character-set substi-
tutions defined in Com-
mands 70 and 71 must be
adjusted if the ASCII
character set is changed.
All previously defined
substitutions are lost from
NV memory when the
character-set selection is
changed.
Refer to the character set
summary tables at the end of
the self test to confirm which
ASCII character is printed for
each of the 3270 hex codes.
Both the EBCDIC and DSC
tables are provided.
Example: &%Z65,2 selects the Code
Page 850 character set.
COMMAND 70: OVERWRITE
EBCDIC (SCS/LU1)
TRANSLATION TABLE
Custom substitutions defined by this
command and stored in permanent
memory are written into the
EBCDIC (SCS/LU1) to ASCII
translation table.
VALUE DESCRIPTION
XX The EBCDIC
character to be
changed (in hex)
YY The substitute
ASCII character for
the EBCDIC
character above
NOTES
Previously stored substi-
tutions are automatically
changed to the new
selection when the same hex
location is specified in the
EBCDIC table.