Filter
Top Products
43
A/C-7P RO, A/C-7S RO
COMMAND 38: TRUE LPI
SPACING
HP PCL only. Because laser printers
have a non-printable border around
the edge of single-sheet pages, 6 LPI
and 8 LPI spacing is compressed
slightly to enable 66 lines and 88
lines to be printed on 11-inch long
paper. This can occasionally cause a
problem, especially when using
preprinted forms that must align
precisely. Command 38 enables a
user to override the laser-printer LPI
compression.
VALUE DESCRIPTION
*0 Compress the
vertical LPI
spacing
1 Print using true 6
and 8 LPI spacing
NOTE
If true LPI is selected, the
user needs to adjust the
document formats to allow
for the reduced number of
lines that can be printed per
page, or the extra lines may
print onto another sheet of
paper.
Example: &%Z38,1 specifies that
vertical spacing prints using true 6
and 8 LPI.
COMMAND 39: CPT ENDING
DELIMITER CHARACTERS
Specifies the two characters to be
used for the ending delimiter
characters for Command Pass-Thru.
VALUE DESCRIPTION
XXYY XX is the ASCII
hexadecimal value
of the first
character and YY is
the ASCII
hexadecimal value
of the second
character.
NOTES
If an ending delimiter is not
selected with this command,
the delimited selected with
Command 40 will be used as
a default.
The default delimiter will no
longer be active if the
command is used to change
it. If Command 39 and
Command 40 are both
entered, Command 39 must
be sent after Command 40 to
be active.
One delimiter character can
be specified instead of two
by entering the hex code for
the character followed by
two zeros (for example,
&%Z39,2500 selects & as the
delimiter).
A hex code that starts with
00 is invalid.
Example: &%Z39,253F specifies
the %? characters as the alternate
ending delimiter characters (%
ASCII hex value is 25 and ? ASCII
hex value is 3F).
*Factory-default setting.