Filter
Top Products
Module Installation
To install the module:
1. Verify the position of the CAL Store Enable Jumper for your
application. The Jumper, as shipped, is in the CAL position. In this
position, a calibration may be performed and the results stored in
non-volatile memory. In the Secured position, a calibration may be
performed, but may NOT be stored in non-volatile memory. This
jumper is described in more detail on page 156.
2. Verify or set the logical address switch as shown in Figure 1-4.
3. Install the module in a mainframe as shown in Figure 1-5.
Installation in a
Mainframe
The HP E1418A may be installed in any slot (except slot 0) in a C-size
VXIbus mainframe. To install in a mainframe:
1. Set the extraction levers out. Slide the module into any slot (except
slot 0) until the backplane connectors touch.
2. Seat the module by moving the levers toward each other.
3. Tighten the top and bottom screws to secure the module in the
mainframe.
Figure 1-5. Installing the HP E1418A in a VXIbus Mainframe
20 Module Setup and Installation Chapter 1