Filter
Top Products
SOURcen:CURRent[:LEVel]:TRIGgered[:AMPLitude]
SOURcen:CURRent[:LEVel]:TRIGgered[:AMPLitude] <value | MIN | MAX | DEF>
outputs the current set in value at channel n when the trigger conditions are satisfied and
the output relay is closed. Use this command to synchronize multiple channel outputs.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
SOURce
n keyword 1 to 8 or 1 to 16 1
<
value>
numeric (float 32) or
discrete
-0.02 Amps to +0.02 Amps or
MIN | MAX | DEF
0
Comments • In the keyword, SOURcen, the valid range of n is:
1 to 8 for E1418A, E1418A Option 002
1 to 16 for E1418A Option 001, E1418A Option 003.
Values of n outside these ranges will generate an error.
• The <value> parameter is a floating point 32-bit number in the range of -0.02 A
to +0.02 A.
MIN sets -0.02 Amps.
MAX sets +0.02 Amps.
DEF sets 0 Amps.
• This command sets channel n to output the current specified following a valid
trigger condition. Following this command, the trigger system must be enabled
using an
INITiate command. See the TRIGger subsystem discussion on page 54
for additional information.
• If the module is in a wait-for-trigger state (INIT has been received) when this
command is received, an error is generated.
• The output state of the channel must be enabled and the trigger event satisfied for
the current to appear at the output terminals.
• If the channel is in the voltage mode when this command is received, an error is
generated.
• Related Commands: SOURcen:CURRent[:LEVel]:TRIGgered[:AMPLitude]?,
SOURcen:FUNCtion:MODE CURRent, OUTPutn[:STATe]
SOURce
Chapter 3 HP E1418A SCPI Command Reference 87