Filter
Top Products
APPLy
The APPLy subsystem enables and outputs a current or voltage on the specified channel.
Subsystem Syntax APPLyn
:CURRent <value | MIN | MAX | DEF>
:VOLTage <
value | MIN | MAX | DEF>
APPLyn:CURRent
APPLyn:CURRent <value | MIN | MAX | DEF> outputs a current on the specified
channel, n.
Parameters
Parameter
Name
Parameter
Type
Range of
Values
Default
APPLy
n
keyword 1 to 8 or 1 to 16 1
<
value> numeric (float 32) or
discrete
-0.02 Amps to +0.02 Amps or
MIN | MAX | DEF
0
Comments • In the keyword, APPLyn, the valid range of n is:
1 to 8 for E1418A, E1418A Option 002
1 to 16 for E1418A Option 001, E1418A Option 003.
Values of n outside these ranges will generate an error.
• The <value> parameter can range from -0.02 to +0.02 Amps.
MIN sets -0.02 Amps output.
MAX sets +0.02 Amps output.
DEF sets 0 Amps output.
• This command is affected by the state of the P/J jumper for this channel on the
terminal module. To use the
APPLyn:CURRent command:
–
the P/J jumper must be set to program selectable or, if set to jumper selectable,
– the V/I jumper must be set to the current mode.
These jumpers are described on page 31.
• Equivalent Commands: SOURcen:FUNCtion:MODE CURR,
SOURcen:CURRent[:LEVel][:IMMediate][:AMPLitude], OUTPutn[:STATe] ON
•
*RST Condition:
– If the P/J jumper is set to program selectable:
output mode is set to voltage, 0 volts output, output relay open.
– If the P/J jumper is set to jumper selectable:
output mode is set by the V/I jumper, 0 volts or amps, output relay open.
APPLy
64 HP E1418A SCPI Command Reference Chapter 3