Filter
Top Products
STATus:OPERation:ENABle?
STATus:OPERation:ENABle? returns the value of the mask set for the Operation
Status Register.
Parameters Returns: 16-bit signed integer (int16).
STATus:OPERation[:EVENt]?
STATus:OPERation[:EVENt]? returns the value of the contents of the Operation
Status Event Register. Reading the register clears all bits in the register.
Parameters Returns: 16-bit signed integer (int16).
Comments • Bit 0 of this register (decimal 1) is the only defined bit in this register.
• This bit is set if the CALibration:CONFigure:RESistance?,
CALibrationn:CONFigure:VOLTage?, or CALibrationn:CONFigure:CURRent?
command has been received and the calibration process is not yet complete.
• *RST Condition: no effect.
• *CLS clears the contents of the Operation Status Register.
• STATus:PRESet does not affect the contents of the Operation Status Register, but
does disable reporting the Summary bit to the Status Byte Register.
STATus:PRESet
STATus:PRESet presets all Enable Registers to 0 (zero). The command has no
effect on Condition or Event Registers.
STATus
Chapter 3 HP E1418A SCPI Command Reference 97