Filter
Top Products
Crimp-and-Insert
Terminal Module
Accessories
The following accessories are necessary for use with crimp-and-insert
Option A3E:
Single-Conductor and
Contact
A crimp-and-insert contact is crimped onto one end of a wire. The other
end is not terminated. Order HP 91510A.
Shielded-Twisted-Pair and
Contacts
A crimp-and-insert contact is crimped onto each conductor at one end of a
shielded-twisted-pair cable. The other end is not terminated. Order
HP 91511A.
Jumper Wire and Contacts A crimp-and-insert contact is crimped onto each end of a single-conductor
jumper wire. This jumper is typically used to tie two pins together in a
single crimp-and-insert connector. Order HP 91512A.
Crimp-and-Insert Contacts These contacts may be crimped onto a conductor and then inserted into a
crimp-and-insert connector. The crimp tool kit is required to crimp the
contacts onto a conductor and remove the contact from the connector.
Order HP 91515A.
Crimp-and-Insert Tools The hand crimp tool (part number HP 91518A) is used for crimping
contacts onto a conductor. The pin extractor tool (part number HP 91519A)
is required for removing contacts from the crimp-and-insert connector.
These products are not included with Option A3E or with the terminal
option accessories listed earlier.
28 Module Setup and Installation Chapter 1