Filter
Top Products
Extra Crimp-and-Insert
Connectors
The crimp-and-insert connector is normally supplied with Option A3E.
Contact Hewlett-Packard if additional connectors are needed.
Order HP 91484B.
Option A3H The Ribbon Cable Connector Terminal Option provides a terminal housing
and ribbon cable connectors. The connectors are designed to be used with
64-pin 0.05 inch center ribbon cables (not provided). Use Figure 1-12 to
make the connections.
Note In Figure 1-12, the center row of each connector is not used in the ribbon
cable. The center row of both connectors is module ground (GND).
Option 135 The Terminal Module Housing Option provides a terminal housing with no
connectors of any type.
The user-supplied connector must be a DIN 41612 type C female,
11.6 mm dimension as shown above.
Figure 1-11. Option A3H Ribbon Cable Connector
Chapter 1 Module Setup and Installation 29