116
1
4
2
3,5
CH01 EXT Ad P1A
[ ]
143
2
CH00 EXT Ad P1A
[ ]
CH00 x y Lv P1
3127 3293 160.0
_
Setting Section Pages 45 to 74
<Selecting the Calibration Standard> Page 50
Not required in the case of flicker measurement**.
1.
Press the key to display the menu selection screen.
2.Press the key to open the calibration stan-
dard selection screen.
3.Press the key until the desired calibration
standard appears.
6500K ←→ 9300K
4. Press the key to confirm the selection.
* The selected calibration standard will be set for CH00
as well as for all the memory channels that have not
been user-calibrated.
When the optional 4-Probe Expansion Board CA-B15 is used
1 Press the key to display the menu se-
lection screen.
2 Press the key to open the PROBE se-
lection screen.
3 Press the key until the desired probe no.
appears.
4 Press the key to confirm the selection.
From the Measurement Preparation section
When performing measurement using Konica Minolta calibration standard
<Setting/Changing the Target Color> Page 62
Not required in the case of flicker measurement**.
1.
Setting/Changing the Target Color by Measurement Page 63
This method can be used for any memory channels
.
HOLD LED
Memory channel
Probe no.
When the optional 4-Probe Expansion Board CA-B15 is used
1 Press the key to display the menu se-
lection screen.
2 Press the key to open the PROBE se-
lection screen.
3 Press the key until the desired probe no.
appears.
4 Press the key to confirm the selection.
Memory channel
Probe no.
1.Press the CH and keys to select the
desired memory channel.
2.Place the measuring probe against the display and
take measurement.
3.Press the HOLD key.
The HOLD LED will light up.
4.Press the key.
5.Press the HOLD key. Measurement will start.
The HOLD LED will light off.
Not required in the case of flicker measurement**.
2.
Setting/Changing the Target Color by Entering Values
Page 65
This method can be used for memory channel CH00 only.
1.
Press the CH
and
keys to select CH00.
2.Press the key.
3.Enter the target color (x, y, Lv).
Ten-key ( to , )...
Used to enter values.
Key ......................................
The cursor moves in
the order
x → y → Lv → x.
4.Press the key.
Cursor
To the Measurement section Page 75
●To set an ID name : *2 <Setting an ID Name> Page 118
●To use the analog display function : *3 <Setting the Analog Display Range>
Page 118
*1
