Filter
Top Products
60
1. Press the MODE key to select analyzer measurement
mode (RGB).
2. Press the MEMORY CH and keys until the
memory channel where you want to input the RGB emis-
sion characteristic appears.
3.Press the key.
The LCD display section will switch to the analyzer mode RGB emis-
sion characteristic input screen.
4. Input the emission characteristic of R.
1 Press the measuring probe against the display, which is now emit-
ting monochrome light of R.
2 Press the key. In the LCD display section, the “*” mark will
appear on the left of “R”.
5. Input the emission characteristic of G.
1 Place the measuring probe against the display, which is now emit-
ting monochrome light of G.
2 Press the key. In the LCD display section, the “*” mark will appear on the left of “G”.
6. Input the emission characteristic of B.
1 Place the measuring probe against the display, which is now emit-
ting monochrome light of B.
2 Press the key. In the LCD display section, the “*” mark will
appear on the left of “B”.
7. Enter the target color (W)
1 Place the measuring probe against the display, which is now emit-
ting the target color(W).
2 Press the key. In the LCD display section, the “*” mark will
appear on the left of “W”.
8.Press the key.
The RGB emission characteristic for the display’s analyzer mode and target color (W) will be set.
* Steps 4 to 7 can be performed in any order.
* Pressing the
, , or key before pressing the key allows you to re-enter the emission characteristic.
*To cancel emission characteristic setting, press the
key before pressing the key.
*To change the target color you set, change it as explained in “1. Setting/Changing the Target Color by Measurement” (page 63).
Even if the target color is changed, the currently set RGB emission characteristic for display’s analyzer mode will remain unchanged.
*
Pressing the MR key displays “100.0” as the target color value for R, B and G.
<Error Messages in LCD Display Section>
…
For other error messages, refer to page 103.
● “E1”
•
Cause 1 : The display’s RGB emission characteristic has never been input for the currently selected
memory channel since shipment from the factory.
Action : This error will disappear if you enter the emission characteristic.
•
Cause 2 : The currently used measuring probe is different from the
one that was used to input the display’s RGB emission
characteristic and target color (W).
Action : Connect the same probe as the one used to input the
display’s RGB emission characteristic and target color (W).
Memory channel
CH01 EXT Ad P1A
E1 [ ]
CH01 EXT Ad P1A
[ ]
CH01 ALZ
P1 W R G B