Filter
Top Products
87
Communications Section
2. Selecting the RS-232C Baud Rate
The RS-232C baud rate can be changed according to the setting made on the computer that is used for remote
measurement.
[Operating Procedure]
1. Press the key.
The LCD display section will switch to the menu selection
screen.
2. Press the key to open the RS232C baud rate
selection screen.
Each time the key is pressed, the screen will switch in the
order PROBE → SYNC → ID Name input → RANGE →
Measurement Speed → Number of Digits → Calibration Stan-
dard → RS232C Baud Rate → PROBE.
3. Press the key until the desired baud rate ap-
pears.
Each time the key is pressed, the baud rate switches in
the order 38400 → 19200→ 9600 → 4800 → 2400 → 1200
→ 600 → 300 → 38400.
4. Press the key to confirm the selection.
* By default (factory setting), the instrument is set so that [38400] will be selected automatically when the POWER switch is set to ON( | ).
* To cancel selection of RS-232C baud rate, press the
key.
<Notes when Selecting the RS-232C Baud Rate>
● The specified RS-232C baud rate will be kept even if the POWER switch is set to OFF(O).
The selected RS-232C baud rate will be effective when the POWER switch is set to ON( | ).
<Reference>
Communication parameter setting (RS-232C)
Set the same communications settings as those on the instrument to the computer.
Baud rate: 38400 (factory setting), 19200, 9600, 4800, 2400, 1200, 600, 300, BPS
Start bit: 1 bit
Character length: 7 bits (ASCII code)
Parity check: EVEN
Stop bit: 2 bits
PQRS
7
TUV
8
WXYZ
MENU
ALPHA
9
GHI
4
JKL
5
MNO LOCK
6
CAL
White
1
ABC
2
DEF
-
SPACE
3
ENTER
Red
0
Green
.
Blue
1
2
3
4
MENU : SELECT
PUSH SPACE KEY
SELECT : BAUD
38400
SELECT : BAUD
19200
SELECT : BAUD
9600
Press the
key until the
desired baud
rate appears.
Menu selection screen
RS-232C baud rate selection screen