Filter
Top Products
4343
Measurement Preparation
[P1]
[P3] [P5]
PQRS
7
TUV
8
WXYZ
MENU
ALPHA
9
GHI
4
JKL
5
MNO LOCK
6
CAL
White
1
ABC
2
DEF
-
SPACE
3
ENTER
Red
0
Green
.
Blue
1
2
3
4
CH00 EXT Ad P1A
[ ]
When the optional 4-Probe Expansion Board CA-B04 is used
Selecting Probe No.
Measurement will be performed simultaneously with all the connected measuring probes. However, the digital and
analog display sections show only the measurement results taken by the one selected probe.
Follow the procedure given below to select the probe connector No. (P1 to P5) to which the desired measuring
probe is connected.
In this example, a measuring probe is connected to the probe connectors [P1], [P3] and [P5].
[Selecting Method]
1. Press the key.
The LCD display section will switch to the menu selection screen.
2. Press the key to open the PROBE selection screen.
Each time the key is pressed, the screen will switch
in the order PROBE → SYNC → ID Name input →
RANGE → Measurement Speed → Number of Digits
→ Calibration standard→ RS232C Baud Rate →
PROBE.
3. Press the key to display the probe no.
you want to select.
Each time the key is pressed, the probe no. switches
in the order [P1]→[P3]→[P5]→[P1].
The probe type is displayed on the right of the probe
serial number by the connected probe.
"C" : LED Universal Measuring ø27 Probe(CA-PU32/35)
"D" : LED Universal Measuring ø10 Probe(CA-PSU32/35)
"A" : LED Flicker Measuring ø27 Probe(CA-P32/35)
"B" : LED Flicker Measuring ø10 Probe(CA-PS32/35)
* When the measurement mode is Flicker Mode, LED Universal Measuring ø27 Probe(CA-PU32/35) or LED Universal Measuring
ø10 Probe(CA-PSU32/35) is not displayed.
Select the measurement mode other than Flicker Mode, if you want to select LED Universal Measuring ø27 Probe(CA-PU32/35)
or LED Universal Measuring ø10 Probe(CA-PSU32/35).
4. Press the key to confirm the selection.
* By default (factory setting), the instrument is set so that [P1] will be
selected automatically when the POWER switch is set to ON( | ).
Menu selection screen
MENU : SELECT
PUSH SPACE KEY
SELECT : PROBE
P1 35881112 A
SELECT : PROBE
P3 35881113
SELECT : PROBE
P5 35881114
Press the key until
the desired probe no.
appears.
PROBE selection screen