LG Electronics STB-3000 DVR User Manual


  Open as PDF
of 85
 
14
206-4272
Setting the Video Output Resolution
The first time you turn ON the STB/display panel, a Please Select the Screen Resolution menu
will be displayed, and you will need to select the appropriate option—720p, 1080p, or 1366 x 768—
for the STB’s video output format. You cannot proceed with STB configuration until you make a
selection.
Note: After it is turned ON, the STB begins an initialization process, and it may take several minutes
for the Screen Resolution menu to be displayed.
Refer to documentation for the applicable display panel(s) to determine the appropriate resolution
setting. The selected resolution should be compatible with the display panel’s native screen
resolution.
PLEASE SELECT THE SCREEN RESOLUTION
720p
1080p
1366 x 768
1. Use the Up/Down arrows on the Installer Remote to select the appropriate video output
resolution option, and then press OK.
The STB’s default video output resolution is 720p. If you select this option, the Please Select
the Screen Resolution screen will close and the EZ-Manager Wizard Welcome screen will be
displayed (see pages 15 to 24 for information on the EZ-Manager Wizard). Proceed with
Commercial Mode setup as required.
If you select one of the other two resolution options (1366 x 768 is selected/highlighted as the
recommended resolution), a Changing Screen Resolution message will be displayed, and the
STB will reboot within a few seconds to change the resolution per your selection. Continue with
step 2.
2. WhentheSTBrebootiscomplete(itmaytakeafewminutes),youwillbepromptedtoconrm
the new video output resolution. Use the arrow keys on the Installer Remote to select YES in the
conrmationscreen,andthenpressOK on the Installer Remote.
Note: Ifthereisnouserinteractionwithin10seconds,orifyouselect“NO”intheconrmation
screen, the STB will reboot and revert to the default resolution. After this reboot is complete, the
Please Select the Screen Resolution menu will be redisplayed.
Onceyouselectandconrmthescreenresolution,theEZ-Manager Wizard will be displayed.
Proceed with Commercial Mode setup as required.
Note: If required at a later time, you can also change the screen resolution in the STB Installer
Menu(item105VIDOUTFORMAT)orviaUSBmemorydevice/TLXle.Ineithercase,theSTB
will need to reboot (see item 105 description on page 37 for additional information).
 previous next