LG Electronics STB-3000 DVR User Manual


  Open as PDF
of 85
 
8
206-4272
STB-3000 Cabling Connections (Cont.)
(Continued from previous page)
While the STB is turning ON and sending the turn ON command to the display, the STB LED blinks at
a constant rate. Once both the STB and the display panel are ON, the STB LED remains lit but blinks
offtwiceinrapidsuccessioneveryveseconds.Therstimageyoushouldseeonthedisplaypanelis
a prompt to select the screen resolution (see “Setting the Video Output Resolution” on page 14).
4. Select the video output resolution (i.e, the STB’s video output format), and complete the appropriate
Commercial Mode setup procedures, as described in this document.
Note: It is recommended that you complete STB-3000 Commercial Mode setup procedures before you
make external equipment connections to the STB-3000.
STB-3000 Cabling Diagram
See also step 2 of procedure above.
MPI
DISPLAY
CONTROL 2
IN 1
(ARC)
IN 2
USB IN 2
USB IN 1
POWER
OUT
LAN
DIGITAL
AUDIO
DISPLAY
CONTROL 1
IR IN
SERVICE
AV IN
AUDIO
LINE OUT
ANTENNA/
CABLE IN
STB-3000 Front Panel
STB-3000 Rear Panel
c) & d) Complete STB Power
and Antenna/Cable connections.
b) Connect HDMI OUT
on STB to HDMI IN on
display panel. **
a) Connect DISPLAY
CONTROL 1 to LG Public
Display or Commercial Monitor
display panel RS-232 port. *
* Only one DISPLAY CONTROL connection
should be used. The proper connection depends
on the type of display panel to be controlled.
** TheSTBdefaultcongurationautomatically
sends Display Control commands to switch the
connected display panel to its HDMI1 input.
a) Connect DISPLAY
CONTROL 2 to LG Hospitality
display panel MPI port or to
commercial non-LG TV MTI
(DATA) port. *
 previous next