LG Electronics STB-3000 DVR User Manual


  Open as PDF
of 85
 
40
206-4272
Custom Master STB Setup (Cont.)
Custom Master STB Setup Procedure
1. Turn ON the STB/display panel.
The next step depends on whether the EZ-Manager Wizard appears
on the screen when you turn ON the STB/display:
• If the wizard is displayed, the STB is in the required factory default
state. Exit the wizard, and then continue with step 2.
• If the wizard is not displayed, restore the STB to a factory default
condition before continuing with this procedure. See Reference
section, “Restoring Factory Defaults on the STB(s),” as necessary,
for further information.
2. Set Installer Menu items.
ThisstepprovidesspecicinstructiononlyontheInstallerMenuitems
that should be set on a Master STB. Refer to pages 29 to 38 for detailed
information on all Installer Menu items.
a) Use the Installer Remote to access the PTC Installer Menu (see
“Accessing the Installer Menu” on page 29 for further information).
b) Set Installer Menu item 003 BAND/AFC, as appropriate.
• Broadcast: Set to 0. • HRC: Set to 2.
• CATV: Set to 1 (default). • IRC: Set to 3.
c) Set any other Installer Menu items that affect your TV programming
network totherequiredconguration.Forexample,setthepanel
display type (if applicable), enable/disable Aux inputs, set a Start
Channel, etc.
d) After you have adjusted all Installer Menu item settings as required,
andifyoudonotneedtocongureanyIPEnvironmentsettings(see
note below), press OK once on the Installer Remote to save your
changes; then, press OK again to exit the menu.
Note:IfyouintendtoconguresettingsintheIPEnvironmentMenu,
which is accessible from the Installer Menu, you can proceed directly
to step 3. All Installer Menu settings will be saved automatically when
you access the IP Environment Menu.
3. Congure IP Environment settings.
Note: You cannot return directly to the Installer Menu from the IP
Environment Menu; thus, you may wish to set all Installer Menu items
as needed before you access the IP Environment Menu. Otherwise,
you will need to reaccess the Installer Menu to set additional items.
Navigate to Installer Menu item 119 DATA CHANNEL, and press
2-5-3 + MENU to launch the IP Environment Menu. Then, complete
networkcongurationasrequired.In particular, if you intend to use
theWi-FiZoningfeature,youmustcongurethewirelessnetwork
connection as part of the Master STB Setup. See “IP Environment
Setup” on pages 54 to 61 for further information.
Typical Installer Menu
Adjust the value for this
Installer Menu item, as required.
003 BAND/AFC 001
(Continued on next page)
STB_3000 PTC INSTALLER MENU
CPU-CTV
000 INSTALLER SEQ 000
UPN 000-000-000-000 ASIC D279
PTC V1.00.008 CPU V3.00.34.01
 previous next