LG Electronics STB-3000 DVR User Manual


  Open as PDF
of 85
 
47
206-4272
Cloning Procedures (Cont.)
(Continued from previous page)
9. When you are ready to initiate the Teaching process, select UPDATE on the screen and then
press OK on the Installer Remote.
CANCEL
BACK
UPDATE
Channel Tuning / Channel Banner Display
Logical
Physical
TEACH TO STB (TLX)
STB MANAGER
Select USB Memory Device
ˇ
USB Device 1:
Device Name
Select the file to download, and then select UPDATE below.
STB-3000-UA00001.TLX
Teaching status will be shown in a pop-up progress banner at the bottom of the Teach To
STB (TLX) screen. This process may take a few minutes. Do NOT remove the USB device
until Teaching is complete. When the Teaching process is complete, an “Updating completed”
messageisbrieydisplayed,andtheSTBManager/USBDownloadMenuisexited(see
also note below).
Note: If you updated the STB configuration with a TLX file that included a change to Installer
Menu item 105 VID OUT FORMAT, once Teaching is completed, a Changing Screen Resolution
banner will be displayed, and the STB will reboot within a few seconds to change the resolution
peryourselection.Thenewscreenresolutionwillalsorequireuserconrmationafterreboot.
See item 105 description on page 37 for further information.
10. Remove the USB memory device from the Target STB, and verify that the appropriate
congurationisnowresidentontheTargetSTB.
Note: IftheTargetSTBwaspreviouslyinPass-throughMode,andtheTLXleusedforTeaching
contained an FTG Channel Map, the Target STB CPU is now in FTG Mode. After the Teaching
process (and,ifapplicable,anSTBreboot/conrmationofnewscreenresolution)is complete,
the STB tunes according to the Start Channel setting in the Installer Menu. If a Start Channel is
specied,theSTBwilltunetothatchannel,though,inthecaseofFTGModeconguration,a
channel banner will only be displayed if the Start Channel is included in the FTG Channel Map
(depending on your selection in step 8, the channel banner will display either the Start Channel’s
logical channel number or physical RF channel number). Otherwise, the STB will either return to
the last channel tuned (STBinPass-throughMode)ortunetotherstchannelintheFTGChannel
Map (STB in FTG Mode). If the latter, remember that the channels in the FTG Channel Map are
always arranged in logical order, regardless of your selection in step 8.
 previous next