Filter
Top Products
79
206-4272
Reference: STB Installer Remote
If you are using an LG display panel, the LG remote provided with the
display panel should be sufficient. However, if you are using a commercial
non-LG display panel and/or if you intend to use multiple STBs/displays in
a single room installation environment, an LG Installer Remote dedicated
to STB control (see example at right) is available for purchase.
The STB Installer Remote illustrated on the right shows typical remote
control functions and is provided for reference only.
For additional information and/or to purchase an STB Installer Remote,
please contact your LG service representative.
Installer Remote Functionality
The STB Installer Remote provides the same standard configuration
functionality as a typical LG Installer Remote, along with multi-code
capability. See also “Installer Remote Control Typical Key Functions”
information on the previous page.
Programming the STB Installer Remote (Multi-IR Code
Feature)
This section describes how to program the STB Installer Remote to send
unique IR codes based on “bed number” in a multi-STB/display single
room installation. Up to nine beds can be programmed.
Note: The STB will always respond to the standard LG Installer Remote
IR code scheme, regardless of its multi-code IR setting.
The following procedure describes how to program the bed number in
the STB Installer Menu and in the STB Installer Remote.
1. Installer Menu item 020 FEATURE LEVEL determines the additional
IR code scheme to which the STB will respond. Access the STB
Installer Menu, and set item 020 to the desired value.
The STB Installer Remote must now be programmed to match the
FEATURE LEVEL setting. That is, if item 020 is set to 17 for Bed 2,
the STB Installer Remote must also be set to Bed 2.
Note: In its default state, the STB Installer Remote uses the standard
LG Installer Remote IR code scheme.
2. On the STB Installer Remote, press and hold OK along with the
desired (bed) number key.
The TV LED at the top left of the remote will light for three seconds
and then turn OFF.
3. Once the TV LED turns OFF, release both keys on the remote.
4. Verify the remote functionality, based on your settings.
Note: If necessary, you can restore the default STB Installer Remote IR
code scheme by pressing and holding OK on the remote along with the
“0” key.
VOL
CH
TIMER
TV
INPUT
SAP
MENU
DVD
CC
MUTE
FLASHBK
VD/
EXIT
GUIDE
INFO
OK
PORTAL