LG Electronics STB-3000 DVR User Manual


  Open as PDF
of 85
 
19
206-4272
EZ-Manager Wizard (Cont.)
Congure Pro:Centric Settings
Once you select “NEXT”fromtheSTBCongurationOptionsscreen,theSearchingforPro:Centric
Server screen is displayed.
Note: Select the “BACK” button, where available, to check previous settings, as necessary.
SEARCHING FOR PRO:CENTRIC SERVER...
EXIT
It may take 2 min 51 second(s).
This step automatically searches for the Pro:Centric Server.
If there is no Pro:Centric server installed, you do not need to continue with this procedure.
Please select either EXIT or MANUAL PRO:CENTRIC.
Status: Tuning channel 30
STB is now searching the pre-defined channels for the data channel...
MANUAL PRO:CENTRICBACK
02
You have the following options:
• YoucanallowtheEZ-ManagerWizardtoproceedwithaseriesofautomatedstepstocongure
the STB for Pro:Centric operation and then to look for the Pro:Centric application and mainte-
nance(E-ZInstallation)lestodownload.Inthiscase,thewizardusesasearchalgorithmto
determine the Data Channel and the Pro:Centric Application Mode to set in the STB.
Continuewiththe“AutomatedPro:CentricConguration”subsectionbelow.
• If you already know the settings (i.e., Data Channel and Pro:Centric Application Mode) that need
tobeconguredinorderfortheSTBtoconnecttothePro:Centricserverand/orifthePro:Centric
server is not yet installed, you may expedite the setup process by entering this data manually.
Continuewiththe“ManualPro:CentricConguration”subsectiononpage21.
Automated Pro:Centric Conguration
Note: If theserverisnotyetconguredonthesystem,usethemanualcongurationoptionto
congurethePro:Centricoperation.Seealsonotebelow.
Note: If Pro:Centric data delivery will be over IP and there is a DNS server at the site, you can
create a DNS entry “procentric.local” for the Pro:Centric server that will enable automated
Pro:CentricIPcongurationviatheEZ-Manager.IfthereisnoDNSentryforprocentric.local,you
mustusethemanualcongurationoptiontocongurethePro:CentricIPoperation.
Once the Pro:Centric data channel is found (a Pro:Centric Server Was Found screen will be
displayed) and the Pro:Centric Application Mode is determined, the wizard will advance to the
ProcessingthePro:CentricCongurationscreen,whichshowstheprogressofthedata
downloads (see example on following page). Note that some steps may require a few minutes.
(Continued on next page)
 previous next