LG Electronics STB-3000 DVR User Manual


  Open as PDF
of 85
 
57
206-4272
IP Environment Setup (Cont.)
Conguring a Wired Network Connection
Note: Ifdesired,youcancongurebothwiredandwireless
connections. However, note that a wired connection is always
prioritized over a wireless connection. That is, when the STB is
turned OFF and then back ON, if a LAN cable is detected between
the STB and the network, the STB will default to the wired
connection. If the LAN cable is removed, the STB will then attempt
to establish the wireless connection. Whenever the LAN cable is
reconnected, the STB will re-establish the wired connection.
1. Connect the appropriate cable between the STB and the network.
2. With the Network Menu on display, use the arrow keys on the
Installer Remote to select Network Setting. Then, press OK. A
second Network screen (see example at right), with Wired and
Wi-Fi Connection setup options, will be displayed.
By default, the STB uses DHCP, and if a LAN cable is detected,
the STB will attempt to connect to the network as soon as you
select “Network Setting” above. If the STB is able to connect to
the network, a “Connected to Internet” message will be displayed
belowtheWiredConnectioneld.
3. IfthenetworkisnotconguredforDHCPoryouwanttospecify
staticcongurationdataoryouwouldliketochangethenetwork
congurationfromManualtoAutomatic,edittheIPconguration
for this STB as follows:
• In the second Network screen, select Wired Connection and
press OK. Then, in the Wired screen, select Edit (if not already
selected) and press OK.
• In the Edit IP screen, select or de-select the “Set Automatically”
checkbox, as required. A checkmark indicates that Automatic
congurationisenabled.
• TomanuallyedittheIPconguration,foreachdataentry
eld:Use the arrow keys on the Installer Remote to select
theeldandpressOK. You can use the number keys on the
Installer Remote to direct enter numeric values or use the
arrow keys to select the appropriate numbers from the pop-up
virtual keyboard displayed at the bottom of the screen. (Note,
however, that you must use the dot “.” key from the virtual
keyboard to separate each octet of an IP address.) When you
are done, select Enter from the virtual keyboard, and then
press OK on the Installer Remote.
• WhenallEditIPeldsaresetasrequired,usethearrowkeys
on the Installer Remote to select Connect and press OK.
At the top of the screen, you will see a progress display that
indicatesstatusaseachnetworkelementisconrmed(see
example at right).
(Continued on next page)
NETWORK
Wired Connection (Ethernet)
Not Connected
Wi-Fi Connection
Not Connected
Pro:Centric
Network
Pre-loaded Apps
EDIT IP
Connected to Internet
Set Automatically
IP Address 10.1.2.4
Subnet Mask 255.255.255.0
Gateway 10.1.2.3
DNS Server 10.1.2.3
DNS
CONNECT
Pro:Centric
Network
Pre-loaded Apps
WIRED
Connected to Internet
IP (Automatic)
IP Address 10.1.2.4
Subnet Mask 255.255.255.0
Gateway 10.1.2.3
DNS Server 10.1.2.3
MAC Address AA:45:F7:52:F8:0F
DNS
EDIT
Pro:Centric
Network
Pre-loaded Apps
 previous next