LG Electronics STB-3000 DVR User Manual


  Open as PDF
of 85
 
45
206-4272
Cloning Procedures (Cont.)
(Continued from previous page)
• IftheTLXlecontainsanFTGChannelMapthatwasLearnedfromanSTB,the physical RF
channels in the FTG Channel Map have been assigned logical channel numbers (see “Learning
CongurationfromaMasterSTB”above).WhenyouTeachtheFTGChannelMaptotheTarget
STB(s), you will have the option to select either logical or physical channel tuning. Even if you
select physical channel tuning, the (list of) physical RF channels in the FTG Channel Map will
remain in logical order.
• IftheTLXlecontainsanFTGChannelMapthatwascreatedintheFTGFileManager,each
logical channel number in the FTG Channel Map has been assigned a physical RF channel, an
IP channel, or an Aux input (the latter designated by 130-0 through 137-0—see also Reference
section,“STBAuxInputConguration”).
Note: When you Teach the FTG Channel Map to the Target STB(s), depending on the types of
channels included in the FTG Channel Map, you may have the option to select either logical or
physical channel tuning. If you select physical channel tuning, the physical RF channels and
Aux inputs in the FTG Channel Map will remain in logical order.
• IftheTLXlewascreatedintheFTGFileManager,itmaycontainmultiplezonedFTGInstaller
MenuprolesfordifferentSTB/TVmodels.MakesureitincludestheappropriateInstallerMenu
prole(s)fortheTargetSTB(s)beforeTeaching.
Caution: Do not unplug the STB power cord or remove the USB memory device
while Teaching, as doing so may cause the STB to malfunction or harm the USB
device, respectively.
Teach Conguration to Target STB
1. Turn ON the Target STB/display panel.
2. The next step depends on whether the EZ-Manager Wizard appears on the screen when you
turn ON the STB/display:
• If the wizard is displayed, you can complete the Teaching process via the wizard, as indicated
above (see “Before You Begin”). However, to continue with this procedure and access the
“Teach to STB (TLX)” option from the STB menus, exit the EZ-Manager Wizard. Then,
continue with step 3.
• If the wizard is not displayed, go directly to step 3.
3. If applicable (see also “Before You Begin” above), make sure to assign the appropriate Zone
designation(s) in the Target STB at this time.
Note: In order for the proper location-specic TV Zone and/or Wi-Fi Zone prole
data to be applied, the Zone designation(s) must be assigned in the Target STB(s)
BEFORE Teaching is performed.
4. InserttheUSBmemorydevicewiththeTLXleintoeitheroftheUSBportsontheTargetSTB.
5. Press MENU on the Installer Remote to display the STB setup menus (STB is in Pass-through
Mode) or the Function Menu (STB is already in FTG Mode).
(Continued on next page)
 previous next