Pelco DX7100 DVR User Manual


 
26 C642M (11/03)
PRESET TOURS
A preset tour is a programmed sequential execution of multiple preset positions.
HOW TO PROGRAM A PRESET TOUR
1. Click the PTZ button in the DISPLAY mode. The PTZ mode appears.
2. Click PRESET. The preset bar appears (refer to Figure 11).
3. Select a camera by moving the mouse pointer to the desired camera view and clicking the left mouse button.
4. Click the TOUR button to turn on tour programming.
5. Click the SET button to turn on preset programming.
6. Click preset buttons in any sequential order to program a tour.
7. To stop programming the preset tour, click the TOUR button.
HOW TO RUN A PRESET TOUR
1. Click the PTZ button in the DISPLAY mode. The PTZ mode appears.
2. Click PRESET. The preset bar appears (refer to Figure 11).
3. Click TOUR.
4. Set the time to switch between presets. The time selection buttons are located above the preset buttons.
5. Click MOVE. The preset tour starts. The number in the preset button turns orange to indicate which preset the tour is on.
6. To stop the tour click MOVE.
7. Click TOUR to exit touring.
HOW TO CLEAR A PRESET TOUR
1. Click the PTZ button in the DISPLAY mode. The PTZ mode appears.
2. Click PRESET. The preset bar appears (refer to Figure 11).
3. Click TOUR.
4. Click CLEAR. The preset tour is now cleared. A preset tour must be cleared before a new preset tour can be programmed.
5. Click TOUR to exit touring.
AUXILIARIES
The auxiliary buttons operate external equipment connected to the auxiliary outputs of Spectra domes or Esprit positioning
systems. Refer the documentation that accompanies your Spectra or Esprit equipment for operating instructions.