Filter
Top Products
40 C642M (11/03)
PATTERNS
The DX7100 can be programmed for one pattern. A pattern is a user-defined, viewable camera path with a definite beginning
and end. The pattern can consist of any standard pan and tilt or lens commands. Once defined the pattern is easily activated
with the press of an on-screen menu button. The pattern will run continuously until it is deactivated with another press of the
menu button.
How to Program a Pattern
1. Click the PTZ button in the DISPLAY mode. The PTZ
mode appears.
2. Select a camera by moving the mouse pointer to the
desired camera view and clicking the left mouse
button. The selected camera number is displayed in the
center of the PTZ controls.
3. Click P-SET. ON appears on the P-SET button. Move the
camera through a series of movements using the pan,
tilt, zoom, and focus commands.
4. To stop programming the pattern, click the P-SET
button.
5. To run the pattern, click the P-RUN button. ON appears
on the P-RUN button. To stop the pattern, click the
P-RUN button.
How To Clear a Pattern
Programming a new pattern will replace (clear) the pattern
previously programmed.
AUXILIARIES
The auxiliary buttons operate external equipment connected
to the auxiliary outputs of Spectra domes or Esprit
positioning systems. Refer the documentation that
accompanies your Spectra or Esprit equipment for operating
instructions.
Figure 24. Pattern Bar