Filter
Top Products
C642M (11/03) 7
7 COPY Button (Backup) – Click the COPY button to format a CD-RW disk and to copy data to the internal CD-RW drive.
Refer to the section on
How to Backup Video Files
for more information.
8 EXIT Button – Click the EXIT button to exit the DX7100 program and shutdown the system.
CAUTION: Do not turn off the power switch on the DX7100 unless your system is locked up. If you must use
the power switch, hold it down until the system turns off.
9 Relay Output Buttons – Click a relay button (1-8) to turn on or off a device, such as a light or alarm, that is connected to
the relay output. A blue button indicates a relay is active.
10 Alarm Input Buttons – A blue button indicates an alarm has been activated. The button will stay blue until the alarm is
cleared.
11 Camera (Motion Detection Status) Buttons – A blue button indicates motion is detected. The button will remain blue until
motion is no longer detected.
12 Screen Division Buttons
Displays a single camera. Displays cameras 1-9.
Displays cameras 1-4. Displays cameras 10-16.
Displays cameras 5-8. Displays all 16 cameras.
Displays cameras 9-12. Sequences using a single-, four-, or nine-camera display.
Displays cameras 13-16. Displays video on full screen; removes all buttons and status
indicators from display. Click the right mouse button to
return to previous screen display.
NOTE: You can also use the left and right mouse buttons to change the screen division.
Single Camera Display Using the Mouse – Move the cursor to a camera view, and click the left mouse button. A green
rectangle appears around the selected view. Click the left mouse button again to display a single camera view of the selected
camera. To return to a 9-camera or 16-camera display, depending on the model, click the left mouse button again. You cannot
return to a 4-camera display from a single camera view.
Full-Screen Display Using the Mouse – Click the right mouse button anywhere on a camera scene to remove all buttons and
status indicators from the display. Click the right mouse button again to return to the previous screen display.
*Settings are not available with DX7108 models.
**On DX7108 models, the last camera input is disabled.
*
*
*
*
**