Filter
Top Products
C642M (11/03) 9
Figure 2. Camera Setup Menu
1 CAMERA NAME Box – To name a camera click the camera selection button for that camera. Up to 70 characters can be
entered in the box.
2 SIGNAL TYPE – Set the NTSC/PAL format for all cameras.
NOTE: The NTSC/PAL switch located on the back panel of the DVR must also be set for the correct signal. Refer to the
installation manual for more information.
3 Camera Selection Button – Select a camera. The scene of the selected camera appears in the viewing window.
4 Camera Enable Button – Enable each camera connected to the camera inputs. This allows all enabled cameras to be
viewed and recorded. If a camera is not connected to an input, disable the camera. Enabling or disabling cameras can
increase or decrease recording rate.
HOW TO SET UP A CAMERA
1. Click the CAMERA ENABLE button to enable a camera for setup. When the camera is enabled, the button is a light blue
color. If the button color is dark blue, the camera is disabled.
2. Click the CAMERA SELECTION button. The camera scene appears in the viewing window.
3. In the CAMERA NAME box, type in the camera’s name.
4. Set the NTSC/PAL format, which applies to all cameras.
1
2
3
4
Ver. 1.3
CAMERA SETUP
Use this screen to enable or disable camera inputs, name cameras, and set signal type (NTSC/PAL).
All cameras are enabled the first time the DX7100 DVR is started. Disable any camera input that is not being used. Disabled
cameras can increase the recording rate for other cameras.