Filter
Top Products
MENU-SPECIFIC SETTINGS2
104 English
(when optional interface board is installed)
NETWORK
SETTINGS
Set timer operation duration and timer recording conditions on a day-specific basis as shown below.
1 Setting timer recording conditions for
different days of the week.
(1) WEEK
These fields specify the days of the week for timer
recording. By using multiple setting rows, it is possible to
setup timer recording a number of different times on a
single day.
(2) START
These fields are used to enter the time at which to start
timer recording.
(3) STOP
These fields are used to enter the time at which to stop
timer recording.
(4) REC RATE
These fields set the recording rate. (JP. 103)
(5) SET
Set these fields to “ON” to set timer recording.
Set these fields to “OFF” when timer recording is not to be
set.
(6) SAT, DLY
When the start and stop times and the recording rate have
been entered and “ON” has been selected for “SET”, you
will be able to carry out timer recording over the same
period every day.
Note that conditions set using “DLY” are given priority over
those set for individual days of the week.
z If “DLY” is set for any other day, all rows will adopt this
setting.
2 Click [SAVE].
Timer setting (or modification) is completed.
Performing timer recording
Click the button on the operation panel. (JP. 96)
Overlapping of timer reservation times
When timer reservation times overlap, priority is given
to the earlier setting.
Setting a timer for over 24-hours continuous
recording
The bottom two lines of the TIMER SET screen are
used to make settings for this type of recording.
(1) Click [OVER 24H] to switch the setting format.
(2) Set the day and time for the start of recording in the
upper row.
(3) Set the day, time, and recording rate for the end of
recording in the lower row.
(4) Select “ON” for “SET” on the bottom row to specify
timer recording extending for over 24 hours.
7. TIMER SET
(1) (2)
(3)
(4) (5)
(6)
For setting timer
recording spanning
more than 24 hours
e00_l8had_us_7.book Page 104 Wednesday, March 10, 2004 2:47 PM