Filter
Top Products
PREPARING FOR USE1
20 English
OPERATION
1 Press the [EXIT/OSD] button repeatedly.
Pressing the [EXIT/OSD] button repeatedly lets you move
or erase the operation display area.
Example: Normal screen
Hard disk recording area
z When an unused hard disk is installed, the initial
recording area settings (normal recording area 80%,
alarm recording area 19%, archive area 1%) are
automatically set at recorder power ON.
z When a hard disk with set recording areas is installed,
the set recording areas are used for recording.
You can check the recording areas of a set hard disk by
selecting “3. RECORDING AREA SET” from the menu.
z When installing a hard disk that was used by another
DVR, check the recording area settings.
[A] Normal recording area
[B] Alarm recording area
[C] Archive area
z If you want to record images while monitoring;...... P. 23
z If you want to record with an end time specified
using timer settings;............................................... P. 23
z If you only want to record when an intruder is
present;............................................................ P. 24, 67
z If you also want to record images from before the
intruder appears; ................................................... P. 25
Changing the position of the
operation display area
Built-in hard disk
[EXIT/OSD] button
Operation
display area
01-01-04
00:00:00EN 10FPS
[B] Alarm recording area
[C] Archive area
[A] Normal recording area
Hard disk’s recording area
80%
1%
19%
Recording
mode
Recording method
Normal
recording
Manual
During monitoring, recording is
performed when the [REC/STOP]
button is pressed.
Timer
recording
Automatic
Recording is carried out in
accordance with timer settings.
Recording
mode
Recording method
Alarm
recording
Automatic
Recording is carried out in
accordance with alarm recording
settings. Specifically, alarm images
are recorded in the alarm recording
area in response to operation of the
switch that has been installed for the
alarm input terminal or to detection of
an intruder or the like using motion
sensors.
Pre-alarm
recording
Automatic
Recording is carried out in
accordance with pre-alarm settings.
Specifically, the same images as
recorded normally over a preset time
interval are repeatedly overwritten in
the alarm recording area until an
alarm occurs. Pre-alarm recording
can be setup to have the digital video
recorder record alarm images before
an alarm input is detected.
Recording
mode
Recording method
Copy Manual
This area is used to copy important
images from the normal recording
area and alarm recording area. By
making changes to the normal
recording area and the alarm record-
ing area, this area can be extended to
up to 10 GB automatically.
Selecting the recording method
[A]
[B]
[C]
e00_l8had_us_7.book Page 20 Wednesday, March 10, 2004 2:47 PM