Filter
Top Products
English 93
(when optional interface board is installed)
2 PREPARING FOR NETWORK CONTROL
1 Launch the PC’s web browser.
Internet Explorer versions 5.0 and later are supported.
In terms of OS, Windows 98, 98SE, Me, 2000, and XP are
supported.
z If the Java Script run-time error message is displayed
while Internet Explorer is being used, modify that
application’s settings as follows:
(1) Select menus in the sequence [Tools] → [Internet
Options] → [Advanced].
(2) Set the [Browsing] checkbox as follows.
2 Enter the URL.
Enter the unit’s URL in the browser’s address bar and then
press [Enter]. (Note that the URL should contain the IP
address specified using the unit’s network settings.)
To start, enter “http://192.168.0.1/” as the default setting.
z If a value other than “80” is set as the default port value,
enter a colon (:) and then the port number after the IP
address.
For example, if the port number was set as “81”, you
should enter
http://192.168.0.1:81/
z If no web browser is installed on the PC, Internet
Explorer must be installed before proceeding.
3 Enter a password (for verification
purposes).
Enter a [User name] and a verification-use [Password] on
the [Connect to 192.168.0.1] screen, and then click [OK].
If you entered an incorrect password, the password entry
screen will appear once again and you will be prompted to
re-input the password.
z Passwords should be setup in advance for the
hardware environment's different user levels. At the
time of purchase, the password settings (i.e., user
name and password) will be as described on P. 110.
z If you save the [User name] and [Password] that have
been entered, verification will be carried out
automatically on subsequent occasions, and they will
not need to be entered again. Note, however, that it
may not be possible to save a password other than that
used for the default connection.
z Up to four PCs can be connected simultaneously to a
single DVR. Note, however, that users with user level
ID2 or ID3 are restricted to use of one PC.
z When four PCs are connected and access is made from
a different PC using the highest user level, the most-
recent user of a lower level to have accessed the unit
will be automatically disconnected and priority will be
given to the upper-level user.
An error message will appear on the disconnected
user's PC. (JP. 95)
z When [Cancel] is clicked after repeated input of an
incorrect password, the authentication error message
will be displayed.
z Even if computer control is being carried out, clicking a
button for which you do not have authorization will
result in the password input screen being displayed to
verify allocation of the required user level.
Controlling from a PC
e00_l8had_us_7.book Page 93 Wednesday, March 10, 2004 2:47 PM