Filter
Top Products
Installation and Configuration Manual 11
Installation
Installation Using ADView and ProLink IIElectrical ConnectionsIntroduction
These three types of standard installation are graphically shown in the following schematic.
2.4.2 Meter orientation
The meter must always be installed horizontally, and orientated to allow flow in the gap between the
tines. This is irrespective of the pipe line orientation, and helps to prevent the trapping of bubbles or
solids on the meter.
To engine
Direct 4-20mA
Direct 4-20mA
Alarms
Relays
Fuel oil
Direct 4-20mA
Heating fluid
Control valve
Visc5.7 cSt
Temp 124°C
Key
1 In-line viscometer replacement
2 Capillary viscometer replacement
3 Micro Motion flow through chamber
1
3
2
Fuel oil heat exchanger