Filter
Top Products
Installation and Configuration Manual 43
Using ADView and ProLink II
Installation Using ADView and ProLink IIElectrical ConnectionsIntroduction Installation Using ADView and ProLink IIElectrical ConnectionsIntroduction Installation Using ADView and ProLink IIElectrical ConnectionsIntroduction Installation Using ADView and ProLink IIElectrical ConnectionsIntroduction
Register Dump / Load
This facility is essential for saving the configuration of your meter. You should use it to save the
current configuration before you start to alter it, in order to restore it if things go wrong for any
reason. Also, if you send the meter away for servicing or re-calibration, you should save the current
configuration. Details are given below.
The Log Setup button – which is
activated when logging has been
stopped – enables you to configure
the frequency of logging, where the
logged data will be filed, and the
format of the data.
Display Selection dropdown
list to select the transmitter
and parameter to be displayed
on the graph
For selecting the
parameter to be
Click Show Graph
to configure and
display graph
For multi-drop
configurations, the
output of up to three
transmitters can be
displayed
simultaneously.
Tabular display of
instantaneous
output of
transmitter.
Select analog
output of another
transmitter.
Click OK to close
Data Logging window
Graphical
representation of
analog output.
Click Start to
start logging.
Click Stop to stop
logging