A SERVICE OF

logo

23. If a drive is already installed in bay 4, remove the four screws attaching the drive
assembly to the disk drive bracket and remove the drive.
24. Set the SCSI ID of the new drive to an address that does not conflict with drives
already installed.
25. Insert the new drive into bay 4 and attach the drive to the disk drive bracket with
four screws.
What to do next?
To install or remove a drive in bay 5, continue with the next step.
If you have no more drives to install or remove, go to step 29 on
page 4-99.
4-98 7043 43P Series User's Guide