A SERVICE OF

logo

Performing an Emergency Eject
Note: Execute the following procedure only in an emergency, such as when the tray
does not open if the unload button has been pressed.
1. Insert a small diameter rod, such as a straightened paper clip, into the
emergency eject hole. (Refer to the illustration below for the location of the
emergency eject access.)
2. Push the tool in until some resistance is felt.
3. Maintain a small amount of pressure on the rod while pulling on the tray with
your finger nail.
4. Pull the tray open and remove the disc.
Tray Opening
Emergency
Eject Access
Load/Unload
Button
Status LightVolume Control
Head Phone
Jack
Note: Normally the tray makes a ratcheting sound when pulling it open using the
above procedure.
2-20
7043 43P Series User's Guide