Filter
Top Products
Chapter 3. Error Code to FRU Index for the Model 140 and
Model 240
Note: For Error Code and Checkpoint information for the Model 150, see
Chapter 4, “Error Code to FRU Index for the Model 150” on page 4-1.
The Error Code to FRU Index lists error symptoms and possible causes. The most
likely cause is listed first. Use this index to help you decide which FRUs to replace
when servicing the system.
If the codes in the following tables indicate a device which is present more than once
in the system unit, a location code is needed to specify which device generated the
error. Go to “Step 1020-4” on page 2-11 to display the System Management
Services error log and obtain a location code. Location code descriptions can be
found under “Firmware Location Codes” on page 3-21.
If you replace FRUs and the problem is still not unresolved, go to “MAP 1540:
Minimum Configuration” on page 2-21 unless otherwise indicated in the tables. If
you replace FRUs and the problem has been resolved, go to "MAP 0410: Repair
Checkout" in the Diagnostics Information for Multiple Bus Systems unless otherwise
indicated in the tables.
Notes:
1. Licensed programs frequently rely on network configuration or system board
information to authorize program use. If the following tables indicate that the
system board or network adapter should be replaced, notify the system owner
that new keys for licensed programs may be required.
2. If a network adapter or the system board is replaced, the network administrator
must be notified so that the client IP addresses used by the server can be
changed. In addition, the operating system configuration of the network controller
may need to be changed in order to enable system startup.
Chapter 3. Error Code to FRU Index for Model 140 and Model 240 3-1