Filter
Top Products
6. All of the latches attaching the front bezel to the chassis are now accessible just
inside the front of the system unit. Release these latches and pull the front bezel
away from the chassis.
7. To remove the power switch, remove the two screws which secure it to the
chassis, then disconnect the power switch cable from the system board.
Replacement
1. Connect the power switch cable to the system board.
2. Fasten the power switch to the chassis with the two mounting screws.
3. Slide the front bezel onto the front of the chassis until the latches are securely
mounted.
4. Slide the media drive bracket assembly towards the front of the chassis and into
position.
5. Secure the media drive bracket assembly to the side of the chassis with the
mounting screw.
6. Connect the media fan cable to the system board.
7. Install the media fan assembly.
8. Install the front fan and speaker assembly as described on “Fan and Speaker
Assembly” on page 8-40
9. Replace the system unit covers as described in “Cover” on page 8-3.
Chapter 8. Removal and Replacement Procedures 8-11