Filter
Top Products
20 01-0870-401B 01/03
Front Panel
Leaving a Parameter If you have not pressed the Enter button, you can leave a
parameter without modifying it by pressing either the:
■ Previous button which returns you to the previous menu level
■ Next button which advances you to the next parameter in the list
In either situation, the TDR6 will ignore any values entered and return the
parameter to its original setting.
After Pressing the Enter Button If you accidentally issue an incorrect parameter
value to the TDR6, you can correct the error by:
1. Selecting the parameter again using the Selection buttons. The parameter will
begin to flash.
2. Change the parameter option to the correct value.
3. Issue the parameter again by pressing the Enter button
Example
The following example describes how to move through menus and select options.
In this example, the video mode will be set to NTSC. This example applies to the
video card located in slot 2, and is for standard definition video.
1. From the DTV Receiver/Decoder main menu, select Details.
2. From the Low Level Setup menu, select Video.
3. From the Video Decoder menu, select Slot 2.
4. From the Slot 2 Video menu, select standard definition.
5. The Standard Definition Video Decoder menu displays, showing the first
video parameter and it’s current setting. Press Next to scroll to the next
parameter.
DTV Receiver/Decoder
Config Details Faults
→
Low Level Setup
Input Service Video
→
Video Decoder Menu
Slot 2
Slot 2 Video Menu
Std_Vid
Std Video Decoder
PID = 33
→