Filter
Top Products
100
•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• Basic operations
Search by Alarm List
This unit stores the start time of alarm recording and emer-
gency recording in the alarm list when such recording be-
gins. This item is used to search the desired picture using
the list of alarm recording (emergency recording). The
search result displays in still frame playback of the single
screen display.
Search by Alarm List
Alarm List
3
D
User Menu
Search
1
steps
1, 2
step
3
step1. Set the month, date, year, hour, minute, second, and
sensor number to be searched.
Latest: Displays the date and time of the latest
recording.
step2. Select “Alarm List.”
• The alarm list may take longer to display completely
when there are many items in the list or when a HDD
has been added.
• The displayed alarm list shows the list of alarm
recordings which has been started before and closest
to the specified time.
step3. Select the alarm list you want to display.
• To change the source device to be searched, set the
desired device in the <Select Source Device> (User
Menu Search Select Source Device). ( See page
42.)
To execute alarm list search while the “Alarm area”
and “Long pre-alarm area” are set, set the playback
area to “Alarm” and “LPA” respectively.
•“Sensor” display indicates the sensor number of which
the alarm signal is input.
• When the repeat recording setting for “Normal
Recording Area” or “Alarm Recording Area” (System
Menu
Memory Data Management Setting for Main
Memory) is set to “Repeat Off” and there is an alarm
recording (emergency recording) at the end of the
HDD, that recording may not be stored in the alarm
list and that item may be missed.
• When the data of the camera number which is not
corresponded to the alarm sensor number is copied
to the external media, the alarm list of that data is not
exactly similar to that of listed in the digital recorder.
• When the detection of the motion or the ground of
the ALARM IN terminal occurs numerously at the
same time, not all the start times of the alarm recording
may be registered in the alarm list. In this case, the
sensor of the lowest number is registered in the list.
• In the alarm list, items with the ALARM IN terminal
grounded are indicated in orange, items that were
detected with motion are indicated in white, items with
the EMERGENCY terminal grounded are indicated
in magenta, and items that were input with alarm
signal via communication are indicated in green.
• To clear the alarm list, erase the HDD data of which
the alarm recording is recorded (System Menu
Data
Clear). Beware that executing it erases all the data of
the HDD contained the picture data.
• Alarm list search is not performed if there are no index
signals.
• When alarm recording (emergency recording) is
started while displaying the <Alarm List>, you must
first exit the <Alarm List> and then display it again.
The new item will be added to the list. In this case,
specifying the date and time to be searched again
may be necessary.
Basic operations (continued)