Filter
Top Products
59
•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• Operations
step6. Test the motion detection function on the condition
you have set.
• The color of the dot detecting motion changes.
step7. To copy another motion detection settings, use
“Same as settings.”
• Select “Copy Motion A” to copy the setting for
the same camera number of Motion B.
• Select “Copy Motion B” to copy the setting for
the same camera number of Motion A.
• When change is detected continuously, some
functions such as setting change are not available
because alarm recording is also continuously
performed. In this case, motion detection function can
be forcibly stopped for five minutes by setting the
“Alarm Input” in the <Recording> menu to “Off.” You
can change the settings by stopping recording during
this time. This stopping is automatically released five
minutes after the operation, and registered in the
system log list. When you cancel the prohibition of
alarm input manually, set it to “On.”
• When both of the ALARM IN terminal on the rear panel
and the motion detection are set for the alarm
recording trigger, the ALARM IN terminal on the rear
panel is always given priority when both of the signals
are input at the same time.
• The M-DET indicator lights up while the motion
detection function is in operation.
• The motion detection of this unit may not operate
correctly depending on the conditions of the input
video signals especially when the “Sensitivity” is set
to high setting. Be careful when connecting to a
system, etc., that is set to alarm when the motion
detection function of this unit is operated.
• To perform alarm recording for motion detection, set
trigger for alarm recording to “MD-A,” “MD-B,”
“External / MD-A,” “External / MD-B,” “External & MD-
A” or “External & MD-B,” and set alarm recording rate
of the corresponding camera number to other than “–
– –.”
• The motion detection of this unit functions by detecting
the changes of brightness. So, the malfunction due
to the change of the lightning or sunlight may occur,
or motion detection does not function on the conditions
such as the colors of the background and the clothes
are the same.
Be sure to test this function sufficiently before
operation.